Dropped Upper Steering Arm Side Steer Un-Polished

Upper Steering Arm Dropped for Hot Rod Side Steer Plain

PART NUMBER:

RSC-40320

Dropped upper steering arm that keeps steering geometry correct with a dropped axle. Raw stainless steel finish. Fits 28 - 48 Ford spindles. Accepts 5/8" or 11/16" Ford tie rod ends. Tapered 7 degrees from bottom side, if needed you can drill to 5/8" to accept a heim joint. SOLD EACH

: $109.99

Qty:

Overview

FEATURES:

For Use With 1928-1948 Ford Spindles

Spindle Mounting Center to Center Width: 3.300"
Mounting Flange to Tie Rod Center: 6 1/8"
Tie Rod End Taper Angle: Ford 7 Degree from Bottom Side

A must have part for any traditional hot rod. 1-1/2" dropped side steer arm to keep the steering arm geometry correct when using a dropped axle. Made from 17-4 stainless steel. The thru bolt design allows it to work with a wide selection of brake kits and even comes dimpled around the grease fitting to allow for a 45 deg. fitting. It really doesn't get any nicer. This item is also available in fully polished stainless finish on this store. Search for Dropped Upper Steering Arm in the search box to learn more.

WHAT'S INCLUDED:

1 (ONE)

Plain Stainless Steel Dropped Upper Steering Arm

NOTES & TIPS:

Taper can be drilled out with a 5/8" drill bit to accept 5/8" heim joint or rod end.

Depending on the axle width, drop, spindles, and tie rod end combination used - a shim or spacer may be required between spindle and steering arm for the tie rod end to clear the axle.