Dropped Upper Steering Arm Side Steer Polished

Polished Upper Steering Arm Dropped for Hot Rod Side Steer

PART NUMBER:

RSC-40319

Dropped upper steering arm that keeps steering geometry correct with a dropped axle. Fully polished stainless steel. Fits 28 - 48 Ford spindles. Accepts 5/8" or 11/16" Ford tie rod ends. Tapered 7 degrees from bottom side, if needed you can drill to 5/8" to accept a heim joint. SOLD EACH

: $129.99

Qty:

Overview

FEATURES:

For Use With 1928-1948 Ford Spindles

Spindle Mounting Center to Center Width: 3.300"
Mounting Flange to Tie Rod Center: 6 1/8"
Tie Rod End Taper Angle: Ford 7 Degree from Bottom Side

A must have part for any traditional hot rod. 1-1/2" dropped side steer arm to keep the steering arm geometry correct when using a dropped axle. Made from 17-4 stainless steel and beautifully polished. The thru bolt design allows it to work with a wide selection of brake kits and even comes dimpled around the grease fitting to allow for a 45 deg. fitting. It really doesn't get any nicer. This item is also available in un-polished stainless steel on this store. Search for Dropped Upper Steering Arm in the search box to learn more.

WHAT'S INCLUDED:

1 (ONE)

Polished Stainless Steel Dropped Upper Steering Arm

NOTES & TIPS:

Taper can be drilled out with a 5/8" drill bit to accept 5/8" heim joint or rod end.

Depending on the axle width, drop, spindles, and tie rod end combination used - a shim or spacer may be required between spindle and steering arm for the tie rod end to clear the axle.