2" Spreader Bar License Plate Brackets Polished

FEATURES:

For Tube Diameter: 2"

Mounting a rear license plate on a hot rod has always been a difficult task for hot rodders. These trick, polished aluminum brackets simplify everything by mounting the license plate to 2" OD tubing (Common for most rear spreader bars.) Designed with a threaded nutsert that presses into spreader bar with a thin flange and can be mounted at any width to accommodate a wide selection of plate applications. Similar front 1 1/2" spreader bar brackets are also available on this store. Search for Spreader Bar License Plate Brackets in the search box to learn more.


WHAT'S INCLUDED:

2 (TWO)

Polished CNC Machined Brackets For License Plate

NOTES & TIPS:

Have an original plate that the upper and lower hole spacing is different than it is on modern plates and you don't want to drill new holes? Try mounting using only the bottom holes and apply double sided tape to hold the top.

Brackets attach to 2" OD tubing with a nutsert. Drilling of spreader bar required.

Note: License plate frame and spreader bar not included, shown for reference only.

Remember to always use Anti-Seize on all stainless steel and aluminum parts.